Longshot Plunger Head

S$9.00

This is a SLA printed plunger head designed to be used with the OMW Workshop aluminum Longshot plunger body. It has a larger diameter than the stock plunger head, but uses the same Longshot o-rings included with the stage 2 Longshot kit. 

OR
  • DESCRIPTION
  • REVIEWS
  • *The image is a CAD rendering; the actual part will be CLEAR.

    Note: This is a 3D printed part and is made to order. As such, there is a longer than usual processing time after an order is placed before the part can be shipped. Please see below for the current turnaround time.

    Current turnaround time: ~1 week

    This is a SLA printed plunger head designed to be used with the OMW Workshop aluminum Longshot plunger body. It has a larger diameter than the stock plunger head, but uses the same Longshot o-rings included with the stage 2 Longshot kit. This plunger head can be attached to the stock plunger rod or the OMW Longshot stage 2 kit plunger rod. Due to the nature of 3D printed components, the tolerances of the o-ring’s groove may vary slightly from print to print, so Teflon tape may be needed to tweak and adjust how the o-ring seals against the plunger body. When installing the o-ring, it may twist as you slide it over the plunger head, you will get a better seal if you use tweezers, a small screwdriver, or needle nose pliers to untwist the o-ring as it sits in its groove.

    Features:

    3D printed part warning:

    This is a 3D printed component and is intended for the serious hobbyist. This is not meant to be a drop in part and there may be variations in surface finish as well as dimensional quality. The end user may need to cut, sand, and/or modify this printed part to achieve their desired fit and/or finish.