O-Tac Gear Hammershot S1 Kit Special Edition


Be the first to review this product

Availability: Out of stock

This kit includes the 6-shot special orange edition cylinder, cylinder pin & screws, hammer, orange trigger, replacement plunger seal, and 8kg spring.

  • The O-Tac Gear Hammer Shot Kit is a drop in kit that converts the cylinder from 5 to 6 shots, changes the hammer angle to make it more ergonomic, and replaces the trigger and mainspring. The cylinder has been completely re-engineered to make room for a 6th dart while also increasing efficiency. The inner diameter of each chamber has been tightened to make the most use out of the available air volume and the mouth of each chamber has been widened and tapered to facilitate easy loading. The cylinder automatically holds the air restrictor in the open position allowing you to use shortened darts without having to ramrod each dart when loading. You can also stack two short darts in the cylinder for double shots with reduced range. The hammer has been re-angled and textured to allow for smooth priming even with the 8kg spring installed.

    Included with this kit:

    • 6-shot orange special edition cylinder 
    • Cylinder pin
    • Cylinder screws (2x)
    • Ergonomic hammer
    • Orange Trigger
    • 8kg mainspring
    • Replacement plunger seal
    • O-Tac Gear stickers


    Be sure to watch our installation for this kit below if you experience any difficulties during installation: